In Fakırcalı mahallesi, Alanya, Antalya, a renovation may look finished while fine dust reappears on window ledges, marks remain on glass, or kitchen cabinet interiors are still not ready for use. Treating all of these as one undefined cleaning request can make the scope unclear. CGS Temizlik is based at Sütçüler Mahallesi 15 Temmuz Şehitler Cd No:109/D, Kepez/Antalya; coverage for Fakırcalı is discussed according to the address and access conditions at 0537 445 01 91.
Matching the service to the actual task
Home cleaning covers kitchens, bathrooms and living spaces with methods suited to the surface. Empty apartment cleaning gives more attention to cabinet interiors, floors and wet areas before moving in. After renovation, bulky waste and fine dust are separate matters, so post-construction cleaning is not the same request as routine home cleaning.
Office and workplace cleaning concerns work areas, shared spaces and toilets, while limits around electronics and documents should be agreed in advance. Apartment and site cleaning focuses on stairs, landings, entrances and common areas. Villa cleaning may be organised around floors, rooms, stairs and windows; pool maintenance is not included. Upholstery cleaning depends on the fabric label and ventilation conditions. Window cleaning is assessed according to accessible glass, frames and surface condition.
Is the renovation complete, or is dust returning?
Dust that becomes visible again after cleaning does not always mean that a surface was missed. If painting, grouting, cutting, drilling or installation continues, fine particles can settle again as doors, cabinets and windows are opened. It helps to clarify whether all touch-ups, skirting installation, silicone work and electrical work are actually complete.
Once the work is complete, a staged approach can be more practical. Larger residue and dust on higher surfaces are addressed first, followed by cabinet exteriors, counters, floors and accessible glass. A final wipe done too early may need repeating after later installation work or ventilation. Paint, mortar and adhesive residue should be identified by surface type, since aggressive scraping can damage some finishes and glass.
Glass marks or surface damage?
Describing where and how a mark appears helps define a window-cleaning request. A film that changes direction when wiped, or looks streaky in the light, may be dust, water residue or product marks. A line that catches a fingernail, a dulled patch, edge wear, or a change in appearance between glass panes may not be resolved by cleaning alone. This distinction helps discuss the scope of window cleaning.
If renovation dust has collected in frames, seals or tracks, mention these separately. Conditions for risky exterior surfaces or high-access work are considered according to access and site conditions.
Separate kitchen cabinet interiors from exterior surfaces
The outside of a cabinet door and the inside of its shelves are different tasks. Exterior surfaces may involve fingerprints, grease film and visible dust. Interior cleaning involves emptying shelves, removing crumbs or installation dust, and using an appropriate method for the cabinet material. State whether interiors will be empty and whether all cabinets or only selected ones are included. For newly installed cabinets, note protective film, silicone residue or delicate surface finishes.
A short checklist before and after cleaning
- Before: Confirm that renovation work is finished, identify water and electricity access, list the rooms involved and note areas that must remain untouched.
- For glass: Explain which side has marks, scratches, haze or residue, and point out broken or loose components.
- For the kitchen: Specify whether cabinet interiors will be empty and whether the request covers only exterior doors or also shelves.
- After: Check glass in daylight, cabinet interiors, counter edges and floor corners together; plan any remaining renovation work separately.
Why can dust reappear after the renovation seems finished?
Fine dust left on enclosed surfaces, cabinet tops or window tracks can become visible again through airflow, use and opening doors. Continuing installation or touch-up work can also create new dust.
Can every line left on glass be removed by cleaning?
No. Dirt and wiping marks may be cleaned, but scratches, wear, coating issues or changes between glass layers can fall outside cleaning work.