You have just picked up the keys to a flat with no furniture inside, yet the cupboard interiors are dusty, the bathroom shows limescale traces, and the windows look streaked from outside. In a situation like this, saying “I need a house cleaning” is rarely enough. When planning cleaning for an address in Düzlen, a neighbourhood of İbradı, naming the part of the job that matters most to you helps set both the scope and the sequence correctly.
A practical way to state a special request
A special request usually becomes clear not through “do this too”, but through “this part is critical for me”. If you want the inside of cupboards wiped, say it as a separate item: a general clean with doors closed is not the same job as wiping each interior surface. The same applies to the area behind radiators, balcony floors, the outer casing of an air conditioner, or the drainage channels of window frames. If these are not mentioned, they may fall outside the agreed scope.
Preparing three short lists before you call makes things easier: (1) the areas that must be done, (2) items or surfaces that should not be touched, (3) points you are unsure about and want discussed on site. The third one matters, because a method cannot be chosen without knowing what the surface actually is — painted, laminate, natural stone. Where the manufacturer's care instructions are unknown, the method is left to on-site assessment.
Work order in an empty flat before moving in
An empty flat is easier to work in than a furnished one, but if the order is wrong the same work gets done twice. The general logic is top to bottom and inside to outside: cupboard interiors and shelves first, then coarse dust around walls and ceilings, then fixed kitchen and bathroom equipment, and the floor last. Windows usually come just before the floor, since water running off the frames can re-soil a cleaned floor.
Access questions shape this decision directly: are water and electricity connected, is the lift usable, where will waste be left? Without clarity here, no realistic scope can be set. If renovation has just finished, the job moves closer to post-construction cleaning, where dust is removed in stages and paint or mortar residue raises surface sensitivity questions. If you only need general preparation before moving in, empty flat cleaning is the better heading.
Marks noticed after glass cleaning
When the light angle changes after cleaning, thin lines, rings or dull patches may appear on glass. Some of these are remaining moisture or detergent traces and look different once dry. Others belong to the glass itself: older surface scratches, dullness that develops on coated glass, or moisture between double glazing, none of which cleaning removes. Confirming this difference with a quick look or a fingertip test is not reliable; telling a scratch, a stain and a coating apart calls for expert assessment.
The most useful step is to review the current state of the windows together before work starts and flag doubtful areas early. Glass cleaning covers reachable panes and frames; risky façade work is outside the scope.
The eight services in brief
- Home cleaning: kitchen, bathroom, living areas; scope agreed in advance.
- Office and workplace: work and shared areas; no handling of electronics or documents.
- Post-construction: coarse debris separated from fine cleaning.
- Empty flat: cupboards, bathroom, kitchen, floors.
- Apartment and estate: stairs, landings, entrances.
- Villa: floor and room sequence; pool care not included.
- Upholstery washing: method per fabric label; stain removal not guaranteed.
- Glass: reachable surfaces.
Checks before and after the work
- Write down your priorities and the items not to be touched.
- Confirm water, electricity and entrance access.
- Review the existing condition of glass and floors together.
- Afterwards, check cupboard interiors and frame channels.
- Look at the glass again once dry, in different light.
In an empty flat, should glass or floors be done first?
Glass usually comes first, since water and dust from the frames fall onto the floor, which is left until last. The exact order depends on the flat's condition and access.
What should I do about a mark left on glass after cleaning?
Let it dry fully and look again in daylight. If the mark remains, ask for an on-site review; whether it is a scratch or a coating trace cannot be stated without examining it.
You can discuss scope and access details for your Düzlen address by phone: CGS Temizlik, Sütçüler Mahallesi 15 Temmuz Şehitler Cd No109/D Kepez/Antalya, 0537 4450191.