In a house with stairs, should cleaning start at the top floor or at the entrance? When a service is being discussed for an address in Çayyazı Mahallesi, Manavgat, this is often the first thing that comes up, because the number of floors, where the staircase sits and what furniture stays in place shape both the order and the length of the work. Below are the decision points that help you describe the job yourself.
Setting the order between floors
The general principle is that dust and water should not travel back across an area already finished. Washing the staircase before the upper rooms are done rarely works; stairs are usually handled last, from the top downwards. If there is a bathroom on each floor rather than a single wet area, the order should be agreed in advance: the upper bathroom can be finished while dry work continues below.
A simple distinction helps. On an empty floor or before moving in, cabinet interiors, floors and wet areas can be completed in one pass; this is close to empty flat cleaning. In a lived-in home, work moves room by room without closing off the areas in use. Where floors, rooms and stairs are planned together, the scope of villa cleaning describes the situation better.
Protection decisions in a furnished home
In a furnished home the real question is deciding in advance which surfaces will be touched. For wood, marble, polished or coated surfaces the method depends on the manufacturer's care instructions; if those instructions are unknown, no specific method can be treated as suitable and the choice is made together. The same applies to upholstery: no treatment is selected before the label is read. Under upholstery cleaning, checking the label and planning ventilation are part of the work, and no promise is made that a stain will fully disappear.
Telling apart a scratch, limescale and a coating on glass is not something the eye settles reliably; it needs expert assessment on site. "Which side is it on" tests done with a fingernail are unreliable and may stress the surface further. For fragile decorative pieces, framed items and electronics, the most practical answer is to move them beforehand or leave them outside the scope.
Our main services in brief
- Home cleaning: kitchen, bathroom, living areas.
- Office and workplace: work and shared areas, toilets; electronics and documents are not handled.
- Post-construction: coarse debris and fine cleaning are separate; dust is removed in stages.
- Empty flat: cabinet interiors, bathroom, kitchen, floors; water and power access needed.
- Apartment and complex: stairs, landings, entrance and shared areas.
- Villa: order of floors, rooms, stairs and glass; pool care not included.
- Upholstery washing: method according to the fabric label.
- Glass cleaning: reachable glass and frames.
Checklist: before and after
- Write down the number of floors and the rooms and wet areas on each.
- List furniture and surfaces not to be touched; set aside those with care instructions.
- State water, power, lift and parking access in advance.
- Decide who passes where while the stairs are wet.
- When work ends, walk floor by floor: floor corners, window frames, cabinet tops, bathroom grouting.
- Point out anything missing on the spot, before the team leaves.
Reviewing the result together
The walkthrough exists to check whether the work matches the scope you described. Surfaces left out, areas still drying and items that were moved are discussed during this round. To clarify scope according to the address and access conditions, you can reach CGS Temizlik on 0537 445 01 91; the main address is Sütçüler Mahallesi 15 Temmuz Şehitler Cd. No:109/D, Kepez/Antalya.
Should stairs always be left until last?
In most multi-storey homes, yes: washing them before the upper rooms are finished carries dust back down. Depending on how the house is used, the order can change and is agreed beforehand.
Can I tell myself whether a mark on glass is a scratch or limescale?
Not reliably, by eye or by touch. The mark is assessed on site, and if the condition of the surface is unclear, no aggressive method is applied.