The windows have been cleaned, the room looks brighter, and then the light hits a certain angle and thin lines appear on the glass. If you are preparing a home in Şatırlı, Serik, you may face the same question everyone asks: is this left over from cleaning, or was the glass already like that? The distinctions below are meant to help you describe the job clearly and inspect it properly afterwards.
Residue or something permanent on the surface
Some marks seen after cleaning come from what remains on the surface: drying streaks, rings from hard-water droplets, haze left by tape or label adhesive. These usually shift as the light changes and become less visible from another angle. Scratches in the glass itself, or damage to coatings such as low-emissivity or solar control layers, stay fixed. Even so, the eye cannot settle this reliably. Scratches, stains and coating issues need an on-site expert assessment. Testing with a fingertip or nail to guess "which side" is not dependable and can add new marks.
A practical approach: look over the existing condition of the glass in daylight before work starts and point out any areas that already concern you. That gives both sides a shared starting point if a mark shows up later. For coated or special glass whose manufacturer care instructions are unknown, a method cannot be chosen in advance, so mention those panes separately. Window cleaning covers reachable glass, frames and sills; risky facade work or working at height is not included.
Ordering the move, the installations and the cleaning
The most common waste is doing the right task at the wrong time. Furniture assembly, kitchen units, air conditioning or curtain rails all mean drilling and dust. Detailed cleaning done before those finish will need repeating within hours.
- Breaking, drilling and painting first; then post-construction cleaning removes coarse debris and dust in stages.
- Before furniture arrives, empty flat cleaning reaches cupboard interiors, bathroom, kitchen and floors far more completely; water and electricity need to be on.
- Glass is usually left to the end, since installation dust and fingerprints show on it immediately.
- If cleaning happens after furniture is placed, agree in advance which surfaces will be out of reach.
Different surfaces, different equipment
One cloth and one product will not do everywhere. Glass and mirrors want lint-free cloths and a squeegee; natural stone, wood and lacquered surfaces need a non-abrasive approach; stainless steel responds to working with the grain. Keeping bathroom and kitchen cloths separate stops a stain travelling from one surface to another. For fabric, the label decides: upholstery work starts with reading it, then method and ventilation are planned accordingly, and full stain removal cannot be promised. Before trying alcohol, acetone or bleach yourself, you need to know the care instructions for that surface.
A short list for describing the job yourself
In brief: home cleaning covers daily living areas; office cleaning sets limits around electronics and documents; post-construction and empty flat cleaning suit the moving period; building and complex cleaning covers stairs, landings and shared areas; villa cleaning follows an order based on floors and use, with pool care excluded; upholstery washing and window cleaning depend on surface condition.
- How many panes, on which floor, is the outer face safely reachable?
- Are installation and painting finished?
- Are water and electricity available?
- Any special surfaces or coated glass, and do you have the care instructions?
- Which room will the furniture go into?
To discuss scope with your address and access details, call 0537 4450191.
What should I do about lines visible after the glass is cleaned?
Note the same area at different times and angles and show it to the team. Residue-based marks can be reworked; anything that looks permanent needs an on-site assessment.
Does it make sense to clean before the installers arrive?
Usually not. Drilling and cutting produce dust. If a room must be used immediately, a partial clean can be done and the detailed work left until after installation.