Picture the same flat in two versions. In the first, the interior glass is wiped before the balcony is touched, and dust drifting through the open door dries into streaks. In the second, the balcony is cleared and cleaned first, the glass follows, and the floor is left for last. Same tasks, different result. For an address in Yukarıçatma (Serik), planning the order often matters more than listing the scope.
The order between balcony, interior glass and floor
The general logic is to move dirt from high to low and from outside to inside. Handling the balcony floor and railing before the interior glass reduces the chance of dust travelling back onto freshly wiped panes. When frames and vents are wiped wet, water runs downward and lands on the floor, so floor work usually belongs at the end. Loose soil from pots, sand or construction residue is better collected dry than wetted into mud.
A mark left after wiping is not always a cleaning failure. It may be a scratch, an older film or coating layer, or chemical etching, and telling these apart requires an on-site expert assessment. Tests where you run a finger or nail along the pane to decide "which side" it is on are not reliable. If you see such a mark, mention it before work begins; glass cleaning is discussed according to reachable panes, frames and current surface conditions, with no promise of risky façade or height work.
Building the schedule around moving and installation
Cleaning after wardrobe, air-conditioning or kitchen installation is almost always more economical: drilling dust, silicone residue and packaging are collected once. Cleaning before furniture arrives has its own advantage, since cabinet interiors, spaces behind drawers and floor corners stay reachable; that is the point of empty flat cleaning. If both stages are needed, treat them as two separate jobs from the start. Water and electricity access, lift availability and where waste can be taken out all shape the plan.
Fabric and drying conditions for upholstery
In sofa cleaning the fabric decides more than the stain does. No method can be called suitable without the manufacturer's care information; if the label is missing or unreadable, say so beforehand. Drying is the second factor: padding left damp in a closed, unventilated room can develop odour. Check whether a window opens and whether the room can stay unused that day. Sofa cleaning carries no stain-removal guarantee; old, heat-set or previously treated marks may remain.
The services in brief
Home cleaning covers kitchen, bathroom and living areas. Office and workplace cleaning covers work and shared areas, with no intervention on electronics or documents. Post-construction cleaning separates coarse debris from fine dust. Empty flat cleaning suits pre-move situations, apartment and site cleaning covers stairs, landings and entrances, and villa cleaning follows a floor–room–stair order; pool maintenance is not included. Sofa and glass cleaning depend on the conditions described above.
Checklist before and after the job
- Are there items, pots or residue to clear from the balcony?
- Is installation, painting or moving finished, or still to come?
- Is the sofa label present, and can the room be ventilated?
- Are water and electricity available, and where does waste go?
- Afterwards: check pane edges, floor corners and door thresholds.
To discuss the address and scope: CGS Temizlik, Sütçüler Mahallesi 15 Temmuz Şehitler Cd. No:109/D Kepez/Antalya, phone 0537 4450191. Service coverage is agreed according to the address and access conditions.