The painter has left, nobody is sure whether the tradespeople will come back for one more day, and a thin film of dust sits over tape and cardboard in the middle of the living room. If this is the scene at your address in Ermenek, Muratpaşa, Antalya, one question comes before the phone call: is the renovation actually finished, or are you in an intermediate stage? The answer changes both the name of the job and the method used.
Finished work or an intermediate stage?
If dust-producing tasks such as plaster sanding, drilling, cutting, painting and grouting are complete, a fine clean makes sense. If the kitchen counter has not arrived, skirting boards are still to be fixed, or a second coat of paint is being discussed for one room, a fine clean done today will most likely be undone soon. Two routes exist: remove coarse debris to make the flat usable and leave the fine clean until the work ends, or close off finished sections and hand over only those. Which suits you is worked out together during the conversation, based on the address, the number of rooms and the remaining tasks. See the scope of post-construction cleaning.
Why dust comes back
A thin layer reappearing a day later usually has one of these causes: fine dust held in the air settles slowly; an air conditioner, fan or open window recirculates it; dust remains in pockets such as suspended ceiling voids, cable channels, socket openings and the tops of cabinets; or work continues in an adjacent section. That is why dust is removed in stages: coarse residue first, then high points and hidden pockets, and floors last. Leaving ventilation and waiting time between stages reduces what the second pass has to collect.
Moisture and equipment by floor covering
The same cloth does not suit every floor. Ceramic and porcelain tile generally tolerate more water; on laminate, parquet and wood, excess water at joints and seams can cause swelling, so a damp rather than wet cloth is preferred. On natural stone such as marble or travertine, and on applications like epoxy or microcement, product choice depends on that surface's own care instructions; calling a method suitable without knowing the manufacturer's or installer's guidance would not be honest. If you have a handover file, a box label or a note from the tradesperson, share it before work starts. The same logic applies to paint splashes, mortar and silicone residue: softening is tried instead of scraping, and if the surface does not allow it, the residue is left in place and reported to you. On glass, residue and a mark in the surface itself are different things; separating them requires expert assessment rather than home tests. Glass cleaning is limited to reachable panes and frames.
The eight services in brief
Home cleaning covers living areas, kitchen and bathroom; empty flat cleaning covers cupboard interiors and floors before a move. In office and workplace cleaning, electronics and documents are not touched. Apartment and site cleaning focuses on common areas; villa cleaning on floor and stair sequence, pool care excluded. Upholstery washing starts with the fabric label; stain removal cannot be promised.
Checkpoints before and after
- Put remaining trade tasks and their dates in writing.
- Confirm whether water and electricity are on.
- Collect care information for floor and counter materials.
- Decide what is rubble to discard and what stays.
- At the end, walk cabinet tops, socket openings, door tops and window edges together.
- Discuss any surfaces left with residue and the reason at handover.
What if I book the fine clean before the trades are done?
Surfaces stay clean briefly; later drilling, sanding or installation creates dust again. A second pass may be needed, so it is better planned from the start.
Why walk through the space together at the end?
Hidden pockets, points left with residue and moisture choices on floors are discussed on the spot. Reviewing the area together makes it easier to handle a missed section the same day. To talk it through: CGS Temizlik, 0537 4450191, Sütçüler Mahallesi 15 Temmuz Şehitler Cd No109/D Kepez/Antalya.