After glass is cleaned, light hitting it from a certain angle can reveal thin lines, hazy patches or small bright spots. Some of these come from drying and wiping direction; others were already there before anyone touched the glass. In a flat or a building entrance in Büyükalan, talking through this difference before work starts prevents most later arguments about whether the cleaning caused it.
A streak, or something permanent in the surface?
Wiping marks usually spread across the whole pane, change visibility as the light angle changes, and shift after a second dry pass. Scratches, abrasion, mineral etching or a factory coating do not disappear with cleaning. This distinction cannot be made by eye alone, and “testing” with a fingertip or nail to decide which side of the glass a mark sits on is unreliable and can add wear. The practical route is to look at suspect areas together before work and check the same spots in the same light afterwards. Where glass is coated, sandblasted or filmed and the manufacturer's care instructions are unknown, no method is assumed suitable in advance; judging scratches, stains and coatings needs expert assessment.
Safe passage at the entrance and on the stairs
In shared areas glass and floor work are often planned for the same day, but a wet step is a far more concrete risk than a streak. Water can run down while entrance and landing glass is cleaned. Stairs can therefore be worked in sections so one side stays usable, with warnings left in place while surfaces dry and residents informed by the management. If there is heavy use, a move-in or a set rubbish hour, saying so beforehand changes the order of work.
Inside the cupboards, or outside faces only?
This is the most commonly confused point in a kitchen. Wiping only cupboard doors and worktops is one scope; emptying cupboards and cleaning shelves and drawers is another. Interior work requires the cupboards to be empty, a surface set aside for the contents, and knowledge of the interior material, since water-sensitive finishes narrow the possible methods. Who does the emptying should be agreed at the start.
A short map of the services
Home, office and villa cleaning cover living areas, kitchens, bathrooms and shared spaces according to use. Apartment and site cleaning covers stairs, landings and entrances. Empty flat cleaning focuses on cupboard interiors, floors and bathrooms before a move and needs water and power access. Post-construction work separates coarse debris from fine dust. Upholstery washing starts with the fabric label; no stain removal guarantee. Glass cleaning is limited to reachable glass.
Check points before and after
- Look at and note any dull, scratched or stained areas on the glass together, beforehand.
- Point out coated, filmed or special glass and any care instructions you have.
- State whether cupboards will be emptied and what the interior material is.
- Share the busiest passage hours in shared areas.
- Check the glass afterwards in daylight and from more than one angle.
- Leave warnings in place until floors are fully dry.
Do lines seen after glass cleaning go away with another pass?
Marks from wiping usually reduce with a second dry pass. If the same appearance stays in the same spot, it may not relate to the cleaning and the surface should be assessed separately.
Can stair glass and floors be done in one visit?
It is discussed according to access and how busy the building is. Glass is usually planned first, floors after, with stairs worked in sections. For address and access details: 0537 445 0191.